Exam CISCO-640-802 v12(2.93) Part 15

141.Refer to the output from the show running-config command in the exhibit. What should the administrator do to allow the workstations connected to the FastEthernet 0/0 interface to obtain an IP address?



A: Apply access-group 14 to interface FastEthernet 0/0.
B: Add access-list 14 permit any any to the access list configuration.
C: Configure the IP address of the FastEtherent 0/0 interface to 10.90.201.1.
D: Add an interface description to the FastEthernet 0/0 interface configuration.

Correct Answers: C

142.Refer to the exhibit. What IP address should be assigned to Workstation A?



A: 192.168.1.143/28
B: 192.168.1.144/28
C: 192.168.1.145/28
D: 192.168.1.159/28
E: 192.168.1.160/28

Correct Answers: C

143.Refer to the exhibit. Which address and mask combination represents a summary of the routes learned by EIGRP?



A: 192.168.25.0 255.255.255.240
B: 192.168.25.0 255.255.255.252
C: 192.168.25.16 255.255.255.240
D: 192.168.25.16 255.255.255.252
E: 192.168.25.28 255.255.255.240
F: 192.168.25.28 255.255.255.252

Correct Answers: C

144.An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports 21, 23 and 25. What types of packets will be permitted by this ACL? (Choose three.)

A:FTP
B:Telnet
C:SMTP
D:DNS
E:HTTP
F:POP3

Correct Answers: D, E, F

145.Why does the data communication industry use the layered OSI reference model? (Choose two.)

A:It divides the network communication process into smaller and simpler components, thus aiding component development, design, and troubleshooting.
B:It enables equipment from different vendors to use the same electronic components, thus saving research and development funds.
C:It supports the evolution of multiple competing standards, and thus provides business opportunities for equipment manufacturers.
D:It encourages industry standardization by defining what functions occur at each layer of the model.
E:It provides a means by which changes in functionality in one layer require changes in other layers.

Correct Answers: A, D

146.Drop



Drag and drop question. Drag the items to the proper locations.
Correct Answers:



147.Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network. The network administrator connected to router Coffee via the console port, issued the show ip route command, and was able to ping the server. Based on the output of the show ip route command and the topology shown in the graphic, what is the cause of the failure?



A: The network has not fully converged.
B: IP routing is not enabled.
C: A static route is configured incorrectly.
D: The FastEthernet interface on Coffee is disabled.
E: The neighbor relationship table is not correctly updated.
F: The routing table on Coffee has not updated .

Correct Answers: C

148.The network security policy requires that only one host be permitted to attach dynamically to each switch interface. If that policy is violated, the interface should shut down. Which two commands must the network administrator configure on the 2950 Catalyst switch to meet this policy? (Choose two.)

A:Switch1(config-if)# switchport port-security maximum 1
B:Switch1(config)# mac-address-table secure
C:Switch1(config)# access-list 10 permit ip host
D:Switch1(config-if)# switchport port-security violation shutdown
E:Switch1(config-if)# ip access-group 10

Correct Answers: A, D

149.What is the maximum data rate specified for IEEE 802.11b WLANs?
A: 10 Mbps
B: 11 Mbps
C: 54 Mbps
D: 100 Mbps

Correct Answers: B

150.Refer to the exhibit. A network associate has configured OSPF with the command:
City(config-router)# network 192.168.12.64 0.0.0.63 area 0
After completing the configuration, the associate discovers that not all the interfaces are participating in OSPF. Which three of the interfaces shown in the exhibit will participate in OSPF according to this configuration statement? (Choose three.)



A:FastEthernet0 /0
B:FastEthernet0 /1
C:Serial0/0
D:Serial0/1.102
E:Serial0/1.103
F:Serial0/1.104

Correct Answers: B, C, D