Exam CISCO-640-802 v12(2.93) Part 9

81.What can be determined from the router output shown in the graphic?



A: 200.1.1.64 is a default route.
B: The output shows that there are three default routes.
C: The output came from router R2.
D: The output came from a router that has four physical interfaces.
E: EIGRP is in use in this network.

Correct Answers: E

82.Which additional configuration step is necessary in order to connect to an access point that has SSID broadcasting disabled?

A: Set the SSID value in the client software to public.
B: Configure open authentication on the AP and the client.
C: Set the SSID value on the client to the SSID configured on the AP.
D: Configure MAC address filtering to permit the client to connect to the AP.

Correct Answers: C

83.Refer to the exhibit. After HostA pings HostB, which entry will be in the ARP cache of HostA to support this transmission?





Please Input correct Answer here:
Correct Answers: D

84.Drop



Drag and drop question. Drag the items to the proper locations.





Drag and drop question. Drag the items to the proper locations.
Correct Answers:



86.LAB



87.Why will a switch never learn a broadcast address?

A: Broadcasts only use network layer addressing.
B: A broadcast frame is never forwarded by a switch.
C: A broadcast address will never be the source address of a frame.
D: Broadcast addresses use an incorrect format for the switching table.
E: Broadcast frames are never sent to switches.

Correct Answers: C

88.Refer to the graphic. Host A has established a connection with the HTTP server attached to interface E0 of the xyz router. Which of the following statements describe the information contained in protocol data units sent from host A to this server? (Choose three.)



A:The destination port number in a segment header will have a value of 80.
B:The destination port number in a segment header will have a unique value greater than or equal to 1023.
C:The destination address of a frame will be the MAC address of the HTTP server interface.
D:The destination address of a frame will be the MAC address of the E0 interface of the abc router.
E:The destination IP address of a packet will be the IP address of the E0 interface of the abc router.
F:The destination IP address of a packet will be the IP address of the network interface of the HTTP server.

Correct Answers: A, D, F

89.What are two reasons a network administrator would use CDP? (Choose two.)

A:to verify the type of cable interconnecting two devices
B:to determine the status of network services on a remote device
C:to obtain VLAN information from directly connected switches
D:to verify Layer 2 connectivity between two devices when Layer 3 fails
E:to obtain the IP address of a connected device in order to telnet to the device
F:to determine the status of the routing protocols between directly connected routers

Correct Answers: D, E

90.What is the purpose of the command shown below?
vtp password Fl0r1da
A: It is used to validate the sources of VTP advertisements sent between switches.
B: It is used to access the VTP server to make changes to the VTP configuration.
C: It allows two VTP servers to exist in the same domain, each configured with different passwords.
D: It is the password required when promoting a switch from VTP client mode to VTP server mode.
E: It is used to prevent a switch newly added to the network from sending incorrect VLAN information to the other switches in the domain.

Correct Answers: A