Exam CISCO-640-802 v12(2.93) Part 20

191.Which are valid modes for a switch port used as a VLAN trunk? (Choose three.)

A:transparent
B:auto
C:on
D:desirable
E:blocking
F:forwarding

Correct Answers: B, C, D

192.Drop



Drag and drop question. Drag the items to the proper locations.
Correct Answers:



193.Refer to the exhibit. A problem with network connectivity has been observed. It is suspected that the cable connected to switch port Fa0/9 on Switch1 is disconnected. What would be an effect of this cable being disconnected?



A: Host B would not be able to access the server in VLAN9 until the cable is reconnected.
B: Communication between VLAN3 and the other VLANs would be disabled.
C: The transfer of files from Host B to the server in VLAN9 would be significantly slower.
D: For less than a minute, Host B would not be able to access the server in VLAN9. Then normal network function would resume.

Correct Answers: D

194.Refer to the graphic. How many collision domains are shown?



A: one
B: two
C: three
D: four
E: six
F: fourteen

Correct Answers: B

195.Refer to the exhibit. The network administrator is in a campus building distant from Building B. WANRouter is hosting a newly installed WAN link on interface S0/0. The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface. How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?



A: Telnet to WANRouter and execute the command show interfaces S0/0
B: Telnet to WANRouter and execute the command show processes S0/0
C: Telnet to WANRouter and execute the command show running-configuration
D: Telnet to WANRouter and execute the command show controller S0/0
E: Physically examine the cable between WANRouter S0/0 and the DCE.
F: Establish a console session on WANRouter and execute the command show interfaces S0/0

Correct Answers: D

196.Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? (Choose two.)





198.Refer to the exhibit. A technician is troubleshooting a host connectivity problem. The host is unable to ping a server connected to Switch_A. Based on the results of the testing, what could be the problem?




197.LAB



Correct Answers: A, C

E:Cisco routers will first attempt to load an image from TFTP for management purposes.
D:Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
C:Router1 cannot locate a valid IOS image in flash memory.
B:Router1 is acting as a TFTP server for other routers.
A:Router1 has specific boot system commands that instruct it to load IOS from a TFTP
server.



A: A remote physical layer problem exists.
B: The host NIC is not functioning.
C: TCP/IP has not been correctly installed on the host.
D: A local physical layer problem exists.

Correct Answers: D

199.A routing protocol is required that supports:

1) routing update authentication
2) an addressing scheme that conserves IP addresses
3) multiple vendors
4) a network with over 50 routers

Which routing protocol fulfills these requirements?

A: RIPv1
B: RIPv2
C: EIGRP
D: OSPF

Correct Answers: D

200.LAB